Software Update (Flex Touch Screen)

DIY/How To

This article gives you detailed steps to update your machine that has a Flex control board and a touchscreen.

Considerations

You must download the files from Dropbox exactly as it's shown here or it will not take.

After updating your software, the machine will go say Temporarily Out of Service until you follow all direction on this page.

After the update, the LED's will turn off when the door is open.

Current Software as of 5/24/22

Go HERE and click Download. 

Go to your Download folder, right click on it and press Extract All

Click Browse, select the thumb drive, press Select Folder, and then Extract. 

Right click on your thumb drive and press Eject. Unplug the thumb drive from your computer. 

Shut your machine off and plug in the thumb drives.

       

Turn the power switch on. The screen will show data transfer in progress for a few minutes.  After the software update is complete, the machine will be temporarily out of service.

                   

Press the service mode button and go to System Updates then press Reset All Settings. 

            

Enter the password 2314 #

Go back to the main Service Mode menu and press Help followed by About.

           

SBC software will be 5070 and Control Board version is 5075.

Go back to the main service mode screen and run motor count.

           

Go to Refrigeration and make sure Cold Food is selected, then check Health Safety. Press the selections that hold perishable items so they're highlighted in blue and press save. 

         

Go to Configuration and pair your motors.

        

           

Set Prices

Exit to Vend Mode and wait for data to transfer successfully.