Double Vending

Dispensing

This article covers what to do when your machine is vending multiple products due to the I-vend sensor issue.

These are the common symptoms when your I-vend sensors are misaligned or need replaced.

-A product vends successfully then another product falls. The machine then says make another selection.

-Your money was taken but a product did not vend.

Make sure that the harness is plugged in at the control board on the top left.

Your I-vend sensor is located on both sides of your delivery bucket. If it's working properly you should see a solid red light in the middle of the I-vend board. If the sensor is misaligned or needs replaced you will see a flashing red light on the I-vend board. 

Go into Service Mode, Shut the door, Press 2 (Motor Count), Press 8 then make a selection. If two products fall that means your I-vend did not detect the product falling which means you need to replace the I-vend sensor.